CISCO MDS 9124 CONFIGURATION GUIDE PDF

Example Cisco MDS Switch Default Port License Configuration. switch# show port-license Available port activation licenses are 0. Cisco MDS Family Quick Configuration Guide. OL Using the Switch Setup Utility Verifying the Module Status CHAPTER. 3. Configuring. Note If a Cisco MDS or switch is used as a core switch, only a nontrunking F PortChannel is supported. Trunking is not supported on.

Author: Mazutaur Vinos
Country: French Guiana
Language: English (Spanish)
Genre: Relationship
Published (Last): 15 May 2016
Pages: 396
PDF File Size: 18.98 Mb
ePub File Size: 14.93 Mb
ISBN: 270-7-14668-199-8
Downloads: 42016
Price: Free* [*Free Regsitration Required]
Uploader: Nigul

If you do not need explicit LUN access control, using the proxy initiator mode simplifies the configuration.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata – Maximum Entropy

Although it can be configured it has no effect. Testing indicates that this is in fact enabled by default. Should say Step 1 Enable the mgmt 0 interface. This is not correct as this does not work.

In this case, using the proxy initiator mode simplifies the configuration. This should be made more clear. Page Figure shows incorrect ip default-gateway Page States in one bullet: You do not need to restart the fcdomain.

You cannot mix ingress and egress interfaces in the same SPAN session. A disruptive reconfiguration may affect data traffic. Cisco Documentation team has internally re-written this mmds Page Information is repeated twice on the same page: The default authentication port is This can mean several configuration tasks for each iSCSI host. It is worded as if it is a requirement but it is in fact not.

  BABYSITTING THE BAUMGARTNERS BY SELENA KITT PDF

About System Message Logging properly configured system message logging server.

You can nondisruptively reconfigure the fcdomain by changing the configured domains on the overlapping links and getting rid of the domain overlap. If you enabled cksco autoreconfigure option on both switches before connecting the fabric, a disruptive reconfiguration RCF will occur. This is not correct.

Proudly powered by WordPress.

This is not true. I am not sure. Gukde routing does not have to be enabled, unless there is a specific topology where IP routing is necessary. When you join two switches belonging to two different stable fabrics that have overlapping domains, the following cases apply: These pages talk about an active mode of fcanalyzer.

This is very redundant and can be combined into one bullet. You basically give the same settings for the IBM blade switch but this is a 24 port not a 20 port.

I think what is meant here cisfo You must be logged in mxs post a comment. If you assign port number for physical portshow can you assign for ports ? Reconfiguration as in changing of domains is always disruptive. Certainly there is either a mistake in the wording or the example. Leave a Reply Cancel configuratiion You must be logged in to post a comment. From time to time I will blog about other things of interest. On the same page I find this block of text very vague and confusing: FCIP uses different ports.

  M.S.TYAGI INTRODUCTION TO SEMICONDUCTOR DEVICES PDF

Should be 8 base ports, which can goto 8 or 16 additional ports. The way its written sounds like if you have a large scale deployment where you need explicit LUN access control you can use proxy-initiator, but its really the opposite.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata

The opinions expressed in this blog are entirely my own and should not be taken as the opinion of my employer. Obviously there was a part of this paragraph that got chopped off somewhere. This blog is mostly about confiburation pursuits in Data Science.